-
June 1st, 2010, 06:37 PM
#1
Senior Hostboard Member
A8's revisited
Hi all:
Happy summer. I recently unearthed and dusted off my A8 clone cabinets I made 4 years ago, this time fitting them with 416-8C's, 807 green drivers (fitted with 23744 8-ohm diaphragms) and N1201-8A crossovers.
My earlier components were: 416-8B, 802-8T, and N1285's set at 1200 Hz.
The system synergy is more pleasing than the earlier combination. So much more balance and less in-your-face highs and mids, though that could also be the less-efficient (smaller magnet) HF driver.
I have used the N1201's in A7 iterations with very pleasing results as compared to the N1285 at 1200Hz.
Altec used the N1201 in some latter-day A-7's (late 70's) as I saw in old ads on line-I can find them on my hard drive if anyone cares.
I recommend the Model 19/N1201 network to anyone for home hifi Altec bass reflex listening.
-
June 1st, 2010, 08:19 PM
#2
Senior Hostboard Member
-
June 1st, 2010, 10:31 PM
#3
Senior Hostboard Member
Re: A8's revisited
Congratulations!
These sound very good. I was contracted for live PA in a small pub at happy hour for live performers. The comments were : " to efficient or revealing". You either chose
a different mic or used the attenuator.Any way they were amateur performers.
With Pro performers I sometimes used Neumann U87 with the attenuator on the off position.
.............
-
June 2nd, 2010, 04:40 AM
#4
Senior Hostboard Member
Re: A8's revisited
-
June 2nd, 2010, 02:09 PM
#5
HB Super Moderator
Re: A8's revisited
Hi Jon, From your photo the port looks to be a bit too small have you tried the cabinet with different port sizes as well during your different combinations.Congrats !! :2thumbsup:
-
June 2nd, 2010, 08:27 PM
#6
Senior Hostboard Member
Re: A8's revisited
Hi and thanks AltecBest (apologies for not recalling your name), and others who commented.
The port is the size shown in the original A8 blueprint from the mid-60's. Later designs showed two tubed ports (A8C), which used the 3156(?correct) 16-inch woofer.
I once asked this board would a bigger port be better for bass and the general opinion was no. Certainly with the current complement of drivers and x-over it has more bass than before, and smoother overall low-to-high response. The MC2100/C28 combo helps too.
It's nice having a few different cabs and drivers around to mix and match, giving quite pleasing results on occasion.
-Jon
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
This forum has been viewed: 28100561 times.
Bookmarks